Sample Manual Control Mission

1. Verify that the timers are synchronized.

∆ Image 6e: Timers

2. Activate Strike Instructor Control panel (Mission-> Strike Instructor Control)
3. Select Aerial Asset 10
4. Select any ‘Observer’ from the drop down menu and Select ‘Msn Type’ 9 Line
5. Select ‘Fuel Limit‘ Unlimited
6. Select ‘Aircraft’ Select ALL
7. Initial Point 56006600
8. Select ‘Target Location’ 61006600
9. Select ‘Weapon’ Hydra Rockets (70mm)and ‘Qty’ 02
10. Click Validate and Execute
11. Select the task from the ‘Task Sections’ table
12. Tick ‘Cleared Hot’ check box
13. Activate ‘Aircraft Analysis’ panel (Analysis -> Aircraft Analysis)
14. Tick ‘Manual Control’ for aircraft 1 of asset 10

∆ Image 6f: Aircraft Analysis view

15. Switch to VBS3

∆ Image 6g: Aircraft control view

16. Right Click on the aircraft control view and set a target to attack.
17. Proceed towards the target and when you are in the firing range as displayed on the firing circle on   the view, then press the ‘Space’ key

∆ Image 6h: Aircraft Control view during an attack

18. Click ‘END TASK’ button on the view to terminate the task or press ‘Esc’ key to release aircraft control and to return to observer view in VBS3.

Note:
In Manual Control a new task cannot be created if the fuel limit time is zero. But setting a new task is possible even if fuel limit time is 00:00:01

User cannot access the bullet camera view while commencing a manual control attack.

If the amount of ammunition available for a particular asset is not sufficient for commencing an attack, creating a task

will not be allowed until the ammunition is refilled.